Triple air filter to remove plastic particles and fumes. Reduced noise level and detachable extruder.
Non-availability of support materials online
Cubicon single plus is an ultimate FFF 3D printer by hyvision system that satisfies your print requirements. The extruders incorporated are detachable so that the maintenance and inspection are very simpler than before and which also helps you in getting appropriate technical support if any issue persists. The leveling tasks are made automatic to have finest print output, while properly maintaining distance between the nozzle and the bed. Your task of cleaning and formation of particulates while printing are reduced by intelligent use of triple air filters (Ulpa, Hepa, carbon filter). These filters removes micro dust, filters toxic gas, and organic compounds and unwanted odors while printing process is going on. The temperature in the heat bed and nozzle is maintained because of the enclosed and air convection functions. Cubicon includes filament detection sensor through which you can avoid print output failure caused because of no supply of filament. And after checking the issue, user can load the filament and resume the print process.
The 4.3inch touch screen user interface at 45 degree angle design impresses the use and increases user experience, and the control options that are used are very intuitive to use and the design is very flat excluding complex menu options. The super coated bed is heated in such a way to avoid manual masking of tape task and to eliminate the need for additional adhesive. The better the design of the printer components the better the operational noise level. The in-built diagnosis system avoids the need for tape or glue. Cubicon single plus heats the bed in short span of time and with the 500 mm/sec print speed prints the model as sooner as possible. The build volume enables larger objects or prototypes.
There are three kinds of filaments supported by cubicon single plus i.e. ABS, PLA, and flexible filament. The connectivity option offered for you is USB instead of SD card, USB cable and Wi-Fi connectivity and you also have internal memory embedded within the printer.
The support for Cubicon is given in the site.